09-16-2007 12:13 PM - edited 03-05-2019 06:30 PM
hi
howto check a port from Catalyst WS-C3550-12T for errors ?
kind regards
piotr
Solved! Go to Solution.
09-16-2007 02:58 PM
Piotr, from cli issue " show interface "
if you are particularly looking for specific interface issue "show interface fastethernet0/#" where # is the port number.
the "show interface fastethernet0/3"
will show interface stats for port 3, look for input errors, CRC, Runts, Giants statistics as these are indicators of communications errors between the port and the connected system. Same principle applies for gigabit interfaces if you have any uplinks. " show interface gigabitethernet0/#.
HTH
Jorge
09-16-2007 02:58 PM
Piotr, from cli issue " show interface "
if you are particularly looking for specific interface issue "show interface fastethernet0/#" where # is the port number.
the "show interface fastethernet0/3"
will show interface stats for port 3, look for input errors, CRC, Runts, Giants statistics as these are indicators of communications errors between the port and the connected system. Same principle applies for gigabit interfaces if you have any uplinks. " show interface gigabitethernet0/#.
HTH
Jorge
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide