01-12-2012 11:09 AM - edited 03-07-2019 04:19 AM
Hi,
I wonder whethere it is possible to check the the IOS version on the standby sup720 of a 6500? if yes, what command would you use?
thanks,
han
01-12-2012 11:47 AM
you can check with
show redundancy
or
remote command standy-rp show version
Riccardo
don't forget to rate and close question if helpful
01-12-2012 11:49 AM
Hi,
If SSO is configured correctly then try "sh redu"
This command will tell you the IOS on the active and stand-by sup
HTH
01-12-2012 12:35 PM
01-12-2012 01:22 PM
Han,
Your Sups are in SSO mode. The primary is active and the stand-by is Hot. You are also running the save version of IOS on both sups. Everything looks good. I am not sure why you had that error.
HTH
01-13-2012 01:44 AM
why don't you print the message you got? you are way too vague
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: