Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Check IOS version on a standby Sup on Cat6500

Hi,

I wonder whethere it is possible to check the the IOS version on the standby sup720 of a 6500? if yes, what command would you use?

thanks,

han

5 REPLIES
Cisco Employee

Check IOS version on a standby Sup on Cat6500

you can check with

show redundancy

or

remote command standy-rp show version

Riccardo

don't forget to rate and close question if helpful

VIP Super Bronze

Check IOS version on a standby Sup on Cat6500

Hi,

If SSO is configured correctly then try "sh redu"

This command will tell you the IOS on the active and stand-by sup

HTH

Community Member

Re: Check IOS version on a standby Sup on Cat6500

Reza,

I was troubleshooting an error. It says redundancy mismatches. When I used the command you recommanded, i could not find anything that showed mismtach. any idea?

Please look at the results from the attached file.

thanks,

Han

VIP Super Bronze

Check IOS version on a standby Sup on Cat6500

Han,

Your Sups are in SSO mode.  The primary is active and the stand-by is Hot.  You are also running the save version of IOS on both sups.  Everything looks good.  I am not sure why you had that error.

HTH

Cisco Employee

Re: Check IOS version on a standby Sup on Cat6500

why don't you print the message you got? you are way too vague

392
Views
0
Helpful
5
Replies
CreatePlease to create content