Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

CISCO 1812 Router VLAN Configuration

Hello.
I have a CISCO 1812 Series Router with FE0-9 interfaces.
I want to configure a VLAN ID 100 with access port FE2-6 and assign an IP address to the VLAN interface.
Can anybody provide me an example regarding configure VLAN on CISCO 1812 Router?
Thanks in advance.

Regards.
Sakibnaz.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Blue

Re: CISCO 1812 Router VLAN Configuration

md.sakibnaz wrote:

Hello.
I have a CISCO 1812 Series Router with FE0-9 interfaces.
I want to configure a VLAN ID 100 with access port FE2-6 and assign an IP address to the VLAN interface.
Can anybody provide me an example regarding configure VLAN on CISCO 1812 Router?
Thanks in advance.

Regards.
Sakibnaz.

router(config)# vlan 100

router(config-vlan)# name v100

note if the above doesn't work then -

router# vlan database

router(vlan)# vlan 2 name v100

router(config)# int vlan 100

router(config-if)# ip address x.x.x.x

router(config)# no shut

router(config)# int fa2

router(config-if)# switchport access vlan 100

router(config-if)# spanning-tree portfast

etc.. for each physical interface you want in vlan 100.

Jon

2 REPLIES
Hall of Fame Super Blue

Re: CISCO 1812 Router VLAN Configuration

md.sakibnaz wrote:

Hello.
I have a CISCO 1812 Series Router with FE0-9 interfaces.
I want to configure a VLAN ID 100 with access port FE2-6 and assign an IP address to the VLAN interface.
Can anybody provide me an example regarding configure VLAN on CISCO 1812 Router?
Thanks in advance.

Regards.
Sakibnaz.

router(config)# vlan 100

router(config-vlan)# name v100

note if the above doesn't work then -

router# vlan database

router(vlan)# vlan 2 name v100

router(config)# int vlan 100

router(config-if)# ip address x.x.x.x

router(config)# no shut

router(config)# int fa2

router(config-if)# switchport access vlan 100

router(config-if)# spanning-tree portfast

etc.. for each physical interface you want in vlan 100.

Jon

Community Member

Re: CISCO 1812 Router VLAN Configuration

Thanks Jon.

Just I got the 1812 in hand & test ur command.

Regards.

Sakibnaz.

4721
Views
5
Helpful
2
Replies
CreatePlease to create content