Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Cisco 2651 IOS upgrade question

I want to upgrade my old IOS on my 2651 router, can you advice me which maximum release can i use on below machine:

Cisco Internetwork Operating System Software

IOS (tm) C2600 Software (C2600-I-M), Version 12.2(5d), RELEASE SOFTWARE (fc1)

Copyright (c) 1986-2002 by cisco Systems, Inc.

Compiled Sat 02-Feb-02 03:36 by kellythw

Image text-base: 0x80008088, data-base: 0x80989870

ROM: System Bootstrap, Version 12.2(6r), RELEASE SOFTWARE (fc1)

Router uptime is 7 minutes

System returned to ROM by power-on

System image file is "flash:c2600-i-mz.122-5d.bin"

cisco 2651 (MPC860P) processor (revision 0x00) with 27648K/5120K bytes of memory

.

Processor board ID JAD06120JJN (3309546866)

M860P processor: part number 5, mask 2

Bridging software.

X.25 software, Version 3.0.0.

2 FastEthernet/IEEE 802.3 interface(s)

32K bytes of non-volatile configuration memory.

8192K bytes of processor board System flash (Read/Write)

Thanks a lot!

P.S. I need to configure on this machine policy based routing and install Serial Module... so i decided to upgrade IOS.

2 REPLIES
bjw Silver
Silver

Re: Cisco 2651 IOS upgrade question

The Cisco IOS upgrade planner still shows the 2651XM supported up to the latest IOS 12.4.13a

Silver

Re: Cisco 2651 IOS upgrade question

You are really limited by your 32mb RAM/8mb Flash. Check http://www.cisco.com/go/fn for features available/memory required for different ios releases for the 2600 series.

This release "c2600-i-mz.12.3-22.bin" will fit your router and it does support PBR.

1193
Views
0
Helpful
2
Replies
CreatePlease to create content