Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

cisco 2821 & wic 1enet

Hi, I ve a new 2821 and and old wic 1 enet?

Is compatible this wic with this router?

Best regards

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Bronze

Re: cisco 2821 & wic 1enet

If you are connecting this 2821 router to 2 ethernet devices, the ethernet ports supplied by this router should be enough.

4 REPLIES
Hall of Fame Super Bronze

Re: cisco 2821 & wic 1enet

It wasn't supported under 2600 series so I highly doubt it's supported under the 2800 series.

http://www.cisco.com/en/US/products/hw/routers/ps214/products_tech_note09186a00800ae37f.shtml

New Member

Re: cisco 2821 & wic 1enet

The cisco 2821 has 2 fastethernet ports,I need to connect one to the swicht and the other one to the lmds device.. is possible? or Ineed ti purchase a 1-lan HWIC or something like this?

Hall of Fame Super Bronze

Re: cisco 2821 & wic 1enet

If you are connecting this 2821 router to 2 ethernet devices, the ethernet ports supplied by this router should be enough.

New Member

Re: cisco 2821 & wic 1enet

the 2821 is wic orhwic empty.

I want to insert a wic 1adsl only.

http://www.cisco.com/en/US/products/ps5854/prod_models_comparison.html

The 2821 has 2 lan ports.. one will the used to the lan and the other one to the lmds ethernet port.

Its ok?

311
Views
0
Helpful
4
Replies
CreatePlease to create content