Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CISCO 2851 IOS Version for T3/E3 card

Hello everyone. I want to avail a DS3 service using CISCO 2851. Well, I had inserted a T3/E3 card in that router tried following IOS but didn't find any other interface except two GE & one FE.

1. c2800nm-advipservicesk9-mz.123-11.T3.bin

2. c2800nm-adventerprisek9_ivs-mz.151-2.T2.bin

3. c2800nm-ipbasek9-mz.151-4.M3.bin

There are two default IOS in that router

1. c2800nm-advipservicesk9-mz.151-4.M8.bin

2. c2800nm-advipservicesk9-mz.151-4.M9.bin

Can anybody please suggest me any other IOS so that I can use T3/E3 card for the service.

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Silver

Hi,

Hi,

In order to recognize the card you need to configure your router via the "card type t3/e3 1" configuration command as suggested during boot. Just after that you should see the new interface displayed. You can try with one of your default IOS.

Best regards,

Antonin

2 REPLIES
Highlighted
Silver

Hi,

Hi,

In order to recognize the card you need to configure your router via the "card type t3/e3 1" configuration command as suggested during boot. Just after that you should see the new interface displayed. You can try with one of your default IOS.

Best regards,

Antonin

New Member

Thanks Antonin. It helped a

Thanks Antonin. It helped a lot.

33
Views
0
Helpful
2
Replies
CreatePlease login to create content