cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
569
Views
9
Helpful
5
Replies

Cisco 28xx network performance on FE interfaces

viki
Level 1
Level 1

Does any one knows what are the average IP performance for 2801,2811,2821,2851 for flows beetwen two onboard FE. With no sepcial features, only NAT nat QOS. No Voice etc.

1 Accepted Solution

Accepted Solutions

Joseph W. Doherty
Hall of Fame
Hall of Fame

Additional considerations when using the document Edison provided,

"only NAT nat QOS" might constitute a service.

The Mbps rating might need to be halved to support full duplex bandwidth.

Basing performance on 64 byte packets is worse case, as packet size increases so does effective bandwidth. With usual packets sizes, you might be able to obtain 2 to 4 times the effective bandwidth.

View solution in original post

5 Replies 5

Edison Ortiz
Hall of Fame
Hall of Fame

Please see the attached document.

HTH

__

Edison.

Hello!, is there a link in the Cisco web to download the routerperformance.pdf int the case it will be updated?

Best Regards!

Fantastic!!!! Thanks!

Joseph W. Doherty
Hall of Fame
Hall of Fame

Additional considerations when using the document Edison provided,

"only NAT nat QOS" might constitute a service.

The Mbps rating might need to be halved to support full duplex bandwidth.

Basing performance on 64 byte packets is worse case, as packet size increases so does effective bandwidth. With usual packets sizes, you might be able to obtain 2 to 4 times the effective bandwidth.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco