Thanks for your response. I am from a CISCO Networking Academy. I am an instructor. My students were learning to configure the routers. They said that they erased the configuration file and restarted the router. Then we experienced the issue.
I have three routers. One of the router is working fine. That too with the same console connection. But when i make the same console connection with the other two routers (in which i have the issue), I experience the junk output and SYS led blinking GREEN.
I tried making the console connection through HyperTerminal as well as with PUTTY.
Leo, Yes, You were right. I tried to vary the baud rate of the HyperTerminal starting from the initial value step-by-step, & got the router output at the fourth range i.e., 4800. The router was in the ROM Monitor mode, I reset the router, changed the configuration register setting to 0x2142. Again i had the junk output, once again in the HyperTerminal, i gave restore defaults.....It was a nice experience...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.