Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 2901 to Palo Alto

I want to aggregate links between a Cisco 2901 router and a Palo Alto firewall

I am running Version 15.2 on the 2901 router and I have a EHWIC-4ESG card installed, making the connections to the firewall

I tried adding a port-channel to the configuration but I am unable to add the switch card interfaces to it?

The option is available when I look at one of the built in interfaces

I am assuming that it is not posible to get this to work on the switch card. Is there any other way I achieve aggregation?

Thanks

Simon

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Cisco 2901 to Palo Alto

Simon

According to this page from Cisco docs this switch module does not support EtherChannel. See this link for details.

http://www.cisco.com/en/US/prod/collateral/routers/ps10536/data_sheet_c78-612808.html

HTH

Rick

3 REPLIES
Hall of Fame Super Silver

Cisco 2901 to Palo Alto

Simon

According to this page from Cisco docs this switch module does not support EtherChannel. See this link for details.

http://www.cisco.com/en/US/prod/collateral/routers/ps10536/data_sheet_c78-612808.html

HTH

Rick

New Member

Cisco 2901 to Palo Alto

Thanks Rick, I thought as much but just wanted to be sure

Hall of Fame Super Silver

Cisco 2901 to Palo Alto

Simon

I am sure that this was not the answer that you wanted to get. I was quite surprised when I found the page with the information because I had assumed that EtherChannel should have been supported. But it is good to know what the reality is.

I am glad that I could find the explanation for your issue. Thank you for using the rating system to mark this question as answered.

HTH

Rick

300
Views
0
Helpful
3
Replies
CreatePlease to create content