Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

cisco 2901

hallo i have a old cisco 1700 and a new cisco 2901.  I have copied the configuration from old to new but when i ping any IP remote i don't have response from it. the front-end to 2901 are two cisco 3600 with hsrp by provider external

why i dont response from ping ??

thank

2 REPLIES

Re: cisco 2901

Hi

Simply copy pasting the config wont help here since you are doing the same with 2 different platforms. You need to identify the ports available in the new router (2901) and make sure you configure them accordingly with respect to your current 1700 configuration.

The port numberings may be different on both the platforms hence you need to spend some identifying the correct ports for usage within the new device (2901).

regds

New Member

Re: cisco 2901

ok, i have configured the correct port.  I use 2901 to routing/natting from an internal LAN (gigabite0/0 to connect my switch 3Com) to another LAN (gigabite0/1 connect to front-end)

From the router 2901 i ping correct to IP front-end 3600, when i ping from pc-client to IP front-end i don't have a response (ping from pc-client to g0/1 have response)

thank

506
Views
0
Helpful
2
Replies