Cisco 2911 - %SYS-3-INVMEMINT: Invalid memory action (malloc) at
It is possible that there is a hardware problem or that there is a software problem. If the problem goes away when you remove the EHWIC that helps to narrow down the problem. If you have replaced the module and still have the problem on a different hardware then it would seem to point toward a software problem. The easy solution might be to try a different version of code.
If the router is under a maintenance contract it might also be good to open a case with Cisco TAC.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...