cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3275
Views
20
Helpful
4
Replies

Cisco 2960 - EEM

Michael Kim
Level 1
Level 1

Quick question.  Does our Cisco Catlayst 2960 (WS-C2960-48PST-l) support EEM (Embedded Event Manager)? Currently running code 12.2(55)SE1.

MySwitch(config)#event ?

% Unrecognized command

SW Image is C2960-LANBASEK9-M

Thanks,

Mike


 

2 Accepted Solutions

Accepted Solutions

Hello Quick answer.....lol Cisco command lookup tool (CLT) states ....NO Res Paul

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

View solution in original post

EEM is not supported on all Cat 2K range.   This is deliberate.

EEM is supported on all Cat 3K and Cat 4K. 

EDIT/UPDATE (December 2019):  EEM is supported on the Catalyst 2960X/XR starting from 15.2(4)E train.  

View solution in original post

4 Replies 4

Hello Quick answer.....lol Cisco command lookup tool (CLT) states ....NO Res Paul

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

So is the feature not supported on that particular model? Do I need to upgrade from LANBASE to IPBASE to gain this feature?

EEM is not supported on all Cat 2K range.   This is deliberate.

EEM is supported on all Cat 3K and Cat 4K. 

EDIT/UPDATE (December 2019):  EEM is supported on the Catalyst 2960X/XR starting from 15.2(4)E train.  

Thank you for taking the time to rate our posts.
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: