12-18-2013 02:20 AM - edited 03-07-2019 05:08 PM
The above is the port status of a problem port , we've connect and Access point to this port . It shows 25650input errors and 8559 CRC error, is it a cabling problem or the port is faulty , what does it means?
12-18-2013 05:38 AM
Hi Raymond,
Normally this points to layer 1 issues please check the following:
1. Check the speed/duplex both the ends
2. Check the cable / fiber / trasnceiver
3. Check by changing the speed and duplexto half or Auto
4. Chek if the grounding is proper
5. Check patch panel (if there is one)
Also this is a link for a cable test check it out:
https://supportforums.cisco.com/docs/DOC-18983
Hope this helps.
12-18-2013 06:04 AM
Post the output to the following commands:
1. sh intereface
2. sh controller eth
3. sh version
Sent from Cisco Technical Support Nintendo App
12-18-2013 07:07 AM
Hi,
Check with cable and if possible run tdr on that port.
CRC is definitely a physical layer issue.
Whats the distance b/w these two endpoints.
Regards,
Guru
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: