Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

cisco 2960 IOS was erased

Dear Friends,

I have cisco 2960 switch, i erased the flash c2960-lanbasek9-mz.150-1.SE.bin  and i updated c2960-lanbasek9-mz.150-1.SE.tar

via tftp server and every thing was done sucessfully, when i reload the switch in hypertrm is showing switch: there i could not do any thing and the next

i restarted the switch from that time i am not able to login hypertrm... in front panel syst led keep on blinking and even thernet port also showing down.

plz help me out....

Thanks

Srinivas.

Thanks & Regards, Srinivas. N.
6 REPLIES
Hall of Fame Super Gold

cisco 2960 IOS was erased

Community Member

cisco 2960 IOS was erased

Hi leolaohoo,

even i am not able to go rom monitor mode....

i am stucked at switch: promt only...

plz help me how to go rom monitor......

Thanks

Srinivas.

Thanks & Regards, Srinivas. N.
Hall of Fame Super Gold

cisco 2960 IOS was erased

Have you tried "flash_init"?

Cisco Employee

cisco 2960 IOS was erased

Srini,

When at switch: prompt, you need to do the flash initialization and load_helper to start the xmodem recovery.

Please follow the link below and it should help.

http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml

Cheers,

-amit singh

Community Member

cisco 2960 IOS was erased

Hi Friends...

now could upload the ios through console..........

Thank you so much,

Srinivas.

Thanks & Regards, Srinivas. N.
Hall of Fame Super Gold

cisco 2960 IOS was erased

Yes you can.  My first post has a link to teach you how to load the IOS via console cable. 

880
Views
0
Helpful
6
Replies
CreatePlease to create content