Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 2960 RESET

                   I have a cisco 2960 that I seemed to have lost the password. Its just a test switch. I would like to know how to reset it to factory default. I have managed to get to a switch: prompt by holding in the small mode button on the front of the switch and pluging in the power but lost from here.

Everyone's tags (3)
1 REPLY
Cisco Employee

Cisco 2960 RESET

Hi Darren,

Run the follwing comands:

     
     flash_init

     load_helper
     dir flash:

     rename flash:config.text flash:config.old

     boot

Please see the following guide for thecomplete procedure:

http://www.cisco.com/en/US/products/hw/switches/ps628/products_password_recovery09186a0080094184.shtml

Kind Regards,
Ivan

**Please grade this post if you find it useful.

Kind Regards, Ivan Shirshin **Please grade this post if you find it useful.
5871
Views
0
Helpful
1
Replies
CreatePlease login to create content