Cisco 2960 switch : how to cascade to or from a Network Extreme Summit 200
Hello all... I have a Cisco 2960 with 48 ports and 2 gigabit ports. I also have a Network Extreme Summit 200 with also 48 ports and 2 gigabit ports. My question is, how to cascade (maybe "bridge" could be the right word) thoses 2 switches. I got very slow performance when they are connected togehter so I assume there's something to configure. Thank you anyone for helping me on this.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...