I just bough a Cisco 2960 switch and I am trying to uplink it to a 24-port PoE 3550 series switch via the PoE input port and when I connect it the 3550 I can see it getting power from the 3550 but for some reason it keeps rebooting itself. But it works normally when I connect it to a 3560 switch.
Has anyone run into this issue before ?
Thanks very much in advance for any inputs / suggestions !!!
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.