cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
386
Views
0
Helpful
1
Replies

Cisco 300-24 - Get dynamic addresses table automatically (by a script or C program)

tatsoplo2012
Level 1
Level 1

Dear all,

I have a Small Business Managed switch Cisco 300-24 ports.

I'm developping a C program to locate some devices connected to the cisco 300-24 switch on a local network. For that I need to access to the dynamic addresses table of the switch.

I can see this table manually via the web interface (http, https) or through the texttview interface (telnet, ssh). But my goal is to get this table automatically from for example a shell script or directly from my C program which already embed the libssh library (http://www.libssh.org/).

Although the Cisco 300 Series is designed to be deployed without using a command-line interface (CLI) likes on standard cisco IOS. Then, the cisco 300-24 does not provide command-lines likes "mac-address-table dynamic" to get directly the dynamic address table.

How can I access directly to the dynamic address table on the cisco 300-24?

Is there a way, some software update, or configuration to disable the textview interface as well to revert to the standard cisco IOS CLI?

I am very blocked by this point Please help me!!

Feel free for further info.

BR,

1 Reply 1

tatsoplo2012
Level 1
Level 1

Hi,

I found an interesting to solve my issue : upgrade the fw to the version 1.1 available at the thread below:

https://supportforums.cisco.com/docs/DOC-17092.

The switch fw can be easealy loaded and changed via the switch web interface .

I upgrade the fw and now have access to the standard IOS command-line interface.

Just now find required command to get the dynamic address table manually, and next automatically ...

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: