ā04-18-2012 01:56 AM - edited ā03-07-2019 06:11 AM
Good morning,
I'm trying to access the swith to erase all users IP information for each line etc,
I've run the following commands
flash_init
load_helper
boot
The switch reboted ok but i cannot access the switch as it has a motd banner and login, how do i go about removing the banner and login so i can reset the switch
Regards
Paul
ā04-18-2012 01:58 AM
Opps sorry almost forgot
I dont have access the user login or password information
paul
ā04-18-2012 02:02 AM
Hi Paul ,
The easy way is to hold the button on the from panel for some time. This will automatically do password recovery.
If you want to do it manualy, after load_helper you should rename the startup config :
rename flash:config.text flash:config.text.old
and after that boot.
Dan
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: