Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 3524 PWR XL - Port Security

Does anyone know if Cisco 3524 switch support port-security? There's no port-security option under the current IOS (3500XL-c3h2-mz-120.5.2-XU.bin).

cv_sw(config-if)#switchport ?

access Set access mode characteristics of the interface

mode Set trunking mode of the interface

multi Set characteristics when in multi-VLAN mode

priority Set 802.1p priorities

trunk Set trunking characteristics of the interface

voice Voice appliance attributes

cv_sw(config-if)#switchport

I am unable to find a compatible matrix that would tell me if it does support port-security. If anyone can point me to the right direction, your input is greatly appreciated.

TIA,

hieu

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: Cisco 3524 PWR XL - Port Security

You are using the wrong command. Go into the interface configuration mode and try the command below:

(config-if)#port ?

There will be a lot of options.

Reference: http://www.cisco.com/en/US/products/hw/switches/ps637/products_configuration_guide_chapter09186a008007e838.html#xtocid18

2 REPLIES
New Member

Re: Cisco 3524 PWR XL - Port Security

You are using the wrong command. Go into the interface configuration mode and try the command below:

(config-if)#port ?

There will be a lot of options.

Reference: http://www.cisco.com/en/US/products/hw/switches/ps637/products_configuration_guide_chapter09186a008007e838.html#xtocid18

New Member

Re: Cisco 3524 PWR XL - Port Security

Danny -

Got it! Thanks for your response.

hieu

420
Views
0
Helpful
2
Replies