Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 3524-PWR-XL uplink configuration

Has anyone used 2 cisco 3524-PWR-XL switches uplinked together to make 48 ports? Is it possible to uplink 2 fastethernet ports so the switches talk to each other. If it can be done does any know what the configuration should be I have used the following with no success.

 

interface FastEthernet0/24
 description Uplink to DBSwitch2 Room 202
 switchport trunk encapsulation dot1q
 switchport trunk native vlan 235
 switchport trunk allowed vlan 1,135,235,1002-1005
 switchport mode trunk
 switchport priority extend trust
 

 

 

Thanks for any help it is greatly appreciated.

 

 

Donovan

2 REPLIES
New Member

I think you might be looking

I think you might be looking to build an etherchannel between the two switches.

 

Please check this link: http://www.cisco.com/c/en/us/support/docs/switches/catalyst-2900-xl-series-switches/21041-131.html

New Member

Thanks  I went through link

Thanks  I went through link and tried commands but it doesn't seem to work.

 

 

Donovan

32
Views
0
Helpful
2
Replies