Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 3550 for home lab, not getting to command prompt

I'm setting up a home lab and bought a 3550 to use as a console server. It is not getting me a command line, but shows the following output and no more:


System Bootstrap, Version 11.0(10c), SOFTWARE
Copyright (c) 1986-1996 by cisco Systems

I don't have any devices hooked up to it yet. I can get command line from a switch using the same cable.

Any ideas are appreciated.

1 REPLY
New Member

Re: Cisco 3550 for home lab, not getting to command prompt

It looks like you do not have a image to load from on the flash. If you can get to the flash card try putting a image file from cisco on it and power it down and back up.

Sent from Cisco Technical Support iPhone App

92
Views
0
Helpful
1
Replies
CreatePlease login to create content