I would like to build a very simple network with a switch divided up into 4 vlan's and a single uplink to a firewall. I would like to assign bandwidth to each of these vlan's. What is the best approach to take for this?
If you are trying to control bandwidth from VLANs to Firewall, than you can use policing on each VLAN or policing/shaping on output interface to firewall. You would have to classify traffic based on source address.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...