Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

cisco 3550 vlans

I'm trying to configure two vlans that will contain two separate subnets. I don't want the subnet to see each other.

Does the configuration below will do the job?

Any comments...

Thanks

int range f0/1 - 12

description Administrative

switchport access vlan 200

switchport mode access

!

int range f0/13 - 24

description Academic

switchport access vlan 100

switchport mode access

!

interface GigabitEthernet0/1

description Trunk to Cisco6509 router

switchport trunk encapsulation dot1q

switchport mode trunk

!

interface GigabitEthernet0/2

switchport mode dynamic desirable

no shut

!

interface Vlan1

ip address 172.31.181.130 255.255.255.192

no shut

!

interface Vlan200

description Administrative

no ip address

no ip route-cache

no shut

!

interface Vlan100

description Academic

no ip address

no ip route-cache

no shut

2 REPLIES

Re: cisco 3550 vlans

Hi,

Even if u didnt not create the svi's it will work fine.

Thanks

Mahmood

New Member

Re: cisco 3550 vlans

Would you not just want to carry the layer 2 vlans up to your 6509 and define the routers (svi) on the 6509? i.e. put interface vlan 100 and vlan 200 on the 6509? An ACL can be applied to prevent the subnets from "seeing" each other.

273
Views
0
Helpful
2
Replies
CreatePlease to create content