i've purchased some of the new 3560 cg catalyst switches. Am looking for some guidance/assistance into the procedure to change the default (vlan 1) to my management vlan (x). I have been successful in the addition of all my vlans inclusive of the management to the switch using the following command "switchport access vlan x" via the command line.
Currently I have CE 500's in my environment which allows you to change the management vlan from the GUI. Any recommendations/ assistance as to how this is now done on the newer model switches via command line or GUI would be greatly appreciated.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...