I am faced with a hardware dilemma and maybe someone could help me. Recently, some older Cisco 24-port switches (3560V2) have been relocated to our department. The problem is that these are DC switches... Is there any possibility to change the DC power supply with an AC power supply? If it can be done, could someone help me with a part number? In case changing the power supply is not possible, is there some sort of adapter that can be used instead?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...