Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 3560V2 Switch RADIUS Issue

Experts,

A Cisco 3560V2 was bought to complete a project at my company. I noticed the IPBase IOS Image was installed. I was unable to configure RADIUS. I upgraded the IOS to the Latest Release of the IPServices IOS Image. I still dont have the capabilities of configuring RADIUS. Any thought on this? Thanks

4 REPLIES
Purple

Cisco 3560V2 Switch RADIUS Issue

Hi,

what do you mean by configure RADIUS ?  Have you rebooted the switch after upgrade ? can you post the output of sh licence

Regards.

Alain

Don't forget to rate helpful posts.
New Member

Cisco 3560V2 Switch RADIUS Issue

Alain,

I'm trying to setup/configure RADIUS on that Switch so I can authenticate to it using my Active Directory credentials. Show license is not a valid command. Its not listed.

Purple

Cisco 3560V2 Switch RADIUS Issue

Hi,

which commands are not accepted ? have you enabled aaa new-model ?

Regards.

Alain

Don't forget to rate helpful posts.
New Member

Cisco 3560V2 Switch RADIUS Issue

Alain,

I have enabled AAA new-model and I'm trying to enter the command "radius-server host ?.?.?.? auth-port 1645 acct-port 1646 key 7 ??????????" Are the commands for configuring RADIUS different on a 3560V2?

298
Views
0
Helpful
4
Replies