Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 3560X 15.01 Universallk9

I cannot get a route map configured on my new Cisco 3560X. When I go into the vlan to apply the routemap the configuration

will not accept the ip policcy command.

2 REPLIES
Green

Cisco 3560X 15.01 Universallk9

Hi,

Look at this link to the config guide

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750x_3560x/software/release/15.0_1_se/configuration/guide/swiprout.html#wp1228588

Check you have followed the guidelines for PBR

To use PBR, you must first enable the routing template by using the

sdm prefer routing

global configuration command. PBR is not supported with the VLAN or default template. For more information on the SDM templates, see

Chapter 8 "Configuring SDM Templates."

Regards

Alex

Regards, Alex. Please rate useful posts.
VIP Super Bronze

Cisco 3560X 15.01 Universallk9

557
Views
0
Helpful
2
Replies