03-21-2012 09:35 AM - edited 03-07-2019 05:42 AM
I cannot get a route map configured on my new Cisco 3560X. When I go into the vlan to apply the routemap the configuration
will not accept the ip policcy command.
03-21-2012 05:49 PM
Hi,
Look at this link to the config guide
Check you have followed the guidelines for PBR
•
To use PBR, you must first enable the routing template by using the
sdm prefer routing
global configuration command. PBR is not supported with the VLAN or default template. For more information on the SDM templates, see
Chapter 8 "Configuring SDM Templates."
Regards
Alex
03-21-2012 06:06 PM
If you are trying to use PBR, you need "IP Services" license:
HTH
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide