Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 3750 and Pagp parameters on interfaces

Hi,

i have a 3750 Stack with two switches. The IOS version on this machines is the c3750-ipbasek9-mz.122-37.SE1.bin one

The IOS is installed on different switches but on this couple i have a trouble.

A normale switch port has the following part of the configuration:

Interface FastEthernet 2/0/15

....

....

....

pagp learn-method physical-port
pagp timer 17671

...

...

end

If we delete the entries with the command:

no pagp learn-method physical-port

no pagp timer 17671

the interface doesn't display them...but after 30 seconds or 1 minute i find again the two lines...

Obviously there are portchannels configured on the stack!!!

What happens?

Thanks for the answer

1 REPLY
Silver

Re: Cisco 3750 and Pagp parameters on interfaces

662
Views
0
Helpful
1
Replies