I have lost IOS image on my cisco 3750 POE switch so I upload the file using xmodem, but when I went to do a boot flash:image_filename.bin I fat finger the name of the file and now the switch does not allow me to type anything in and I keep on getting a error message on UNKNOWN CMD:(1:2fjf) LINE TOO LARGE and just keeps scrolling the same message.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...