Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

cisco 3750 - stacking and vlans

I have two 3750 switches stacked.

I created a vlan giving

vlan 10

name test

then i gave the vlan 10 an interface ip address.

"interface vlan 10

ip add 10.20.4.1 255.255.255.0"

BUT the problem is I cant ping this inteface even being inside the switch.

There is an ip for the vlan 1 and i can ping that ip.

"sh vlan brif" - shows vlan 10 is active

I tried "no shutdown" in the vlan interface. No result

ip routing is also enabled.

I have been doing intervlan routing with 3750. but this is the first time with 2 switches stacked. Is stacking to do anyting with vlans.

Please help

2 ACCEPTED SOLUTIONS

Accepted Solutions
New Member

Re: cisco 3750 - stacking and vlans

are the switchports assigned to vlan 10?

switchport access vlan 10

Re: cisco 3750 - stacking and vlans

Hi Prasanga,

Check the output of show interface vlan 10.

I am sure it won't be UP and UP.

The reason might be because there is no switch port elonging to VLAN 10 as pointed in the above post.

Connect a PC on an interface. Configure that interface for VLAN 10. Wait untill the physical interface comes up and then again check the output of show interface vlan 10. Now it should be up and up and you should be able to ping it from the swithc and other devices as well as long as they have IP connectivity.

Conclusion - there should be an interface assigned to that VLAN and that particular physical interface should be up. Only then the VLAN interface would come up.

-> Sushil

4 REPLIES
New Member

Re: cisco 3750 - stacking and vlans

are the switchports assigned to vlan 10?

switchport access vlan 10

New Member

Re: cisco 3750 - stacking and vlans

U are correct.

Thanks a lot

Re: cisco 3750 - stacking and vlans

Hi Prasanga,

Check the output of show interface vlan 10.

I am sure it won't be UP and UP.

The reason might be because there is no switch port elonging to VLAN 10 as pointed in the above post.

Connect a PC on an interface. Configure that interface for VLAN 10. Wait untill the physical interface comes up and then again check the output of show interface vlan 10. Now it should be up and up and you should be able to ping it from the swithc and other devices as well as long as they have IP connectivity.

Conclusion - there should be an interface assigned to that VLAN and that particular physical interface should be up. Only then the VLAN interface would come up.

-> Sushil

New Member

Re: cisco 3750 - stacking and vlans

U are correct

Thanks a lot

214
Views
0
Helpful
4
Replies