I have been searching through the 3750 user manual looking for information on egress shaping from the 3750. I can only see references to bandwidth with SRR, there is no mechanism to shape large bursts of traffic. Unfortunately, we cannot police the traffic with storm-control, we need to queue the traffic. The traffic in question occurs for around 1 millisecond and sends around 400,00 packets/sec upstream to a device that can only support 320,000 packets/sec causing the upstream device to tail drop. We would prefer if the 3750 shaped it down to lets say 300,000 over 2 ms. Is this possible on the 3750?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...