I seems to have a weird problem whereby clients are unable to get an ethernet connection (Port no LED lit/not connected) when using mac. Sometimes there is connection after multiple insert/disconnect using the same cable to the Mac client. This has also be tested with a direct connection between the client and switch (without going thru the backbone cabling). If I was to try using Windows client, there does not seems to have such issue.
Further observation; from the switch; if a shut and no shut was performed on the port connected to the client, it would cause the connection to be "UP". Not too sure if anyone may have seen similar issues of unable to get connection "UP"? The firmware on the switch is running 15.2(1)E2.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...