Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CISCO 3845 PoE Troubleshooting help

<p>I have a 3845 with a WIC-D-9ESW-POE module.  I had a CISCO VoIP phone configured to fa 0/1/0 and it stopped working.  I currently have an amber light constantly lit on fa 0/1/p without anything connected and with or without the por being shutdown.  I have also tried my VoIP phone on other ports of this same router and it does not power up.  I have reset the router and powered it off and back on with no change.  I am suspecting the power daughter board to be defective but am wondering if there is a precise test method I can perform to verify this.  Can I check a voltage on the ethernet cable and if so what pin and what voltage should I have.  Also is there a command I can execute to try and reset the power problem.</p>

1 REPLY

Re: CISCO 3845 PoE Troubleshooting help

Try Reseating the module again and if it doesnt help raise an RMA with Cisco

Narayan

 

477
Views
0
Helpful
1
Replies