We're running 20 stacks of cisco 3850 with IOS 03.03.00SE. As a part of the project, we started migrating the authentication services from an old ACS to a new ISE. We are running 802.1x for the laptops and MAB for the Cisco IP Phones
On the first day, we've migrated 5 stacks and almost everything went fine, excepting 3 IP Phones (different models) which didn't autenticate. We've debugged but no messages came up on the switch. After that, we reloaded the stack with the same configuration and the phones successfuly auhtenticated
For now, the problem is solved, but we still have to migrate 15 stacks and the costumer is afraid of that happening again
What might be the problem? I can't find anything in the release notes
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...