I have a above switch with redundant power supplies in Bay 1 and 2. The status indicator is green on the supervisor module, but turns amber when we shutdown one of the power supplies. The switch functions fine with only 1 power supply, but wondering why the status turns amber from green.
That is a system warning light and it will turn amber when one of the installed power supplies is turned off or fails . This is a normal function. It may not go amber if you actually pulled the power supply out of the slot where it could not sense there was a power supply actually installed in that slot , don't know for sure though... The 2nd power supply is there for redundancy in case one fails . Whats better having a spare running or having a whole switch of potentially hundreds of users down until you can find a replacement..
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...