Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Cisco 4403e Boot Problems

I am new to this and have ran into some problems. I butilt up my router I was able from the rom> prompt to get my router to boot from SLOT0:xxxxx

Then I did the copy command copy slot0:xxxxxxx bootflash:xxxxxxx

My router starts up fine. I did all my configurations and did my copy run start when I was done. As this is what I do on my 3750s.

My router lost power and rebooted and I lost everything it did not boot up to my last configuration.

How do I save my configurations when I am done ?

How do I get it to boot from that configuration every time?

Everyone's tags (1)
1 REPLY
Hall of Fame Super Blue

Cisco 4403e Boot Problems

How do I save my configurations when I am done ?

Command:  wr

How do I get it to boot from that configuration every time?

Save the config using the "wr" command.  Everytime the router boots, it will always boot the startup-config file found in the NVRAM (command:  dir nvram:).

206
Views
0
Helpful
1
Replies
CreatePlease to create content