Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 4500 and redundant supervisors possible problem

Hi. I have a Cisco 4500 switch with two supervisor modules. The modules are supposed to be in failover state but I get the following results when entering sh module and sh redundancy states:

sh module

Mod Ports Card Type Model Serial No.

---+-----+--------------------------------------+------------------+-----------

1 2 Supervisor II+ 1000BaseX (GBIC) WS-X4013+ xxxxx

2 Supervisor

sh redundancy states

my state = 13 -ACTIVE

peer state = 1 -DISABLED

Mode = Simplex

Unit = Primary

Unit ID = 1

Redundancy Mode (Operational) = Non Redundant

Redundancy Mode (Configured) = RPR

Split Mode = Disabled

Manual Swact = Disabled Reason: Simplex mode

Communications = Down Reason: Simplex mode

client count = 22

client_notification_TMR = 240000 milliseconds

keep_alive TMR = 9000 milliseconds

keep_alive count = 0

keep_alive threshold = 18

RF debug mask = 0x0

It was my belief that the second supervisor should be recognized right away. Could this indicate that the second supervisor module isn't working correctly?

1 REPLY
Bronze

Re: Cisco 4500 and redundant supervisors possible problem

peer state = 1 -DISABLED

This indicates that second supervisor is either not present or hadn't booted up.

Mode = Simplex

This specifies that chassis is not in redundancy.

Check if the second sup is in ROMMon and bring it up.

719
Views
0
Helpful
1
Replies