Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Cisco 4500 Standby Sup In Disable Mode

Hi,

I have a Cisco 4500 as my core switch and there are two sup eng in this core. However, I noticed that the redundant sup is in diable mode rather than Hot Standby.

I have tired to enable the module but I am not able to do that. Please assist to advice on what I can/should do.

The sup of my core is:

WS-X45-SUP6L-E

Thks and Rgds

Everyone's tags (5)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Cisco 4500 Standby Sup In Disable Mode

Console into the "standby" module and reboot.  Post the entire bootup process.

Make sure both the primary and secondary supervisor card has THE SAME IOS version.

1 REPLY
Hall of Fame Super Gold

Cisco 4500 Standby Sup In Disable Mode

Console into the "standby" module and reboot.  Post the entire bootup process.

Make sure both the primary and secondary supervisor card has THE SAME IOS version.

1514
Views
0
Helpful
1
Replies
CreatePlease to create content