Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Cisco 4500x replace vss member

I was wondering if anyone has ever had to replace a member of a VSS particulary with the Cisco 4500x series. I have seen the document on replacing a 720 sup module for the Cat 6500 series, but I am wondering if there is anything particular for the 4500x when replacing one of the actual switches.

Thanks!

Lance

Everyone's tags (3)
3 REPLIES
Silver

Cisco 4500x replace vss member

Lance,

The procedure of changing the SUP in 4500 VSS is same as 6500 VSS.

You may like to go through the following:

https://supportforums.cisco.com/docs/DOC-29472#_Some_key_point_to_be_remembered_for_Cisco_4500_VSS

http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4500/15-1-2/XE_340/configuration/guide/config/vss.html

Thanks

Ankur

"Please rate the post if found useful"

Community Member

Cisco 4500x replace vss member

This is a 4500x which does not have a supervisor module installed.  I think what I need to do is the basic VSS configuration on the replacement switch:

Create the virtual switch domain

Assign lower priority to replacement switch

Configure VSL port channel and ports

Configure replacement swtich for virtual switch mode

Silver

Cisco 4500x replace vss member

Lance,

I missed its a 4500x, so obviously no sup... my bad.

Anyways the procedure still remains the same and the steps that you have mentioned above are the one you have to perform.

Thanks

Ankur

1043
Views
0
Helpful
3
Replies
CreatePlease to create content