That's so stranger, Recently, we found this problem more than 3 times. when we disconnect the cisco ip phone from 4507 switch, and then connect again, it cannot power on any more, when I connect to 4507 switch, "show power inline" command displayed the port is " Ieee PD" cannot displayed the IP Phone 7945... but when I move the cable to 3750 switch, show power inline command, it dispalyed as IP Phone 7945.
We have the same issue in three 4507 switch, no matter what I change the new cable or new IP phone. doesn't work... I don't if the switch 4507 port have some problem or how to reset the power inline to default. or you may have the same problem before when you deployed the cisco IP phone to your network replace PBX phones.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...