10-14-2013 12:55 AM - edited 03-07-2019 04:01 PM
pls suggest how to recover the standby supervisorn from rommon mode
10-14-2013 02:23 PM
Hello,First of all, you must check boot configuration and where you put the IOS image.Copy the same IOS image than it's on active supervisor, in the standby supervisor, poweroff chasis and extract active supervisor.Now, following this procedure:http://www.cisco.com/en/US/products/hw/switches/ps663/products_configuration_example09186a0080094ecf.shtmlBest regards.Sent from Cisco Technical Support iPad App.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
