Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 4507R+E switch...svi interface is not pinging.

last day i went to one client for the installation of C(WS-C4507R+E)

current ios :cat4500e-ipbase-mz.122-53.SG2.bin

there is only one sup engine installed and  redundant slot is empty.

I installed one ethernet module in the slot 6 and it get detected working fine.

I also want to install one fiber module but that module is only supported by 12.2 54 sg or later ios version.so i need an ios upgrade.

For the ios upgrade

I decide to do it through svi interface

For that i igive an ip address to vlan 1 (192.168.1.2) and plug cable in gigabit 6/1 and added that port into valn 1.

my laptop's ip is 192.168.1.1

@ this point i faced a rare problem the PING IS NOT WORKING.(switch is directly connected to my laptop).

Then i create another VLAN (2) and add that port into vlan 2 still ping is not getting.

last thing i tried is that making that gigabit port into a routed port and result is same.

please help me.

Everyone's tags (2)
4 REPLIES
Cisco Employee

Cisco 4507R+E switch...svi interface is not pinging.

Hello,

Can you please post the output of the following commands?

  • show run int vlan1
  • show run int gi6/1
  • show vlan brief
  • show int vlan 1
  • show int gi6/1

Thank you!

Best regards,

Peter

New Member

Cisco 4507R+E switch...svi interface is not pinging.

Switch(config)#do sh ip int bri

Interface              IP-Address      OK? Method Status                Protocol

Vlan1                  192.168.1.1     YES manual down                  down   

Vlan2                  192.168.10.1    YES manual up                    up     

FastEthernet1          192.168.3.1     YES manual down                  down   

TenGigabitEthernet3/1  unassigned      YES unset  down                  down   

TenGigabitEthernet3/2  unassigned      YES unset  down                  down   

GigabitEthernet3/3     unassigned      YES unset  down                  down   

GigabitEthernet3/4     unassigned      YES unset  down                  down   

GigabitEthernet3/5     unassigned      YES unset  down                  down   

GigabitEthernet3/6     unassigned      YES unset  down                  down   

GigabitEthernet6/1     unassigned      YES unset  up                    up     

GigabitEthernet6/2     unassigned      YES unset  down                  down   

GigabitEthernet6/3     unassigned      YES unset  down                  down   

GigabitEthernet6/4     unassigned      YES unset  down                  down   

GigabitEthernet6/5     unassigned      YES unset  down                  down   

GigabitEthernet6/6     unassigned      YES unset  down                  down   

GigabitEthernet6/7     unassigned      YES unset  down                  down   

GigabitEthernet6/8     unassigned      YES unset  down                  down   

GigabitEthernet6/9     unassigned      YES unset  down                  down   

GigabitEthernet6/10    unassigned      YES unset  down                  down   

GigabitEthernet6/11    unassigned      YES unset  down                  down   

GigabitEthernet6/12    unassigned      YES unset  down                  down   

GigabitEthernet6/13    unassigned      YES unset  down                  down   

Switch(config-if)#do sh vla

VLAN Name                             Status    Ports

---- -------------------------------- --------- -------------------------------

1    default                          active    Te3/1, Te3/2, Gi3/3, Gi3/4

                                                Gi3/5, Gi3/6, Gi6/2, Gi6/3

                                                Gi6/4, Gi6/5, Gi6/6, Gi6/7

                                                Gi6/8, Gi6/9, Gi6/10, Gi6/11

                                                Gi6/12, Gi6/13, Gi6/14, Gi6/15

                                                Gi6/16, Gi6/17, Gi6/18, Gi6/19

                                                Gi6/20, Gi6/21, Gi6/22, Gi6/23

                                                Gi6/24, Gi6/25, Gi6/26, Gi6/27

                                                Gi6/28, Gi6/29, Gi6/30, Gi6/31

                                                Gi6/32, Gi6/33, Gi6/34, Gi6/35

                                                Gi6/36, Gi6/37, Gi6/38, Gi6/39

                                                Gi6/40, Gi6/41, Gi6/42, Gi6/43

                                                Gi6/44, Gi6/45, Gi6/46, Gi6/47

                                                Gi6/48

2    VLAN0002                         active    Gi6/1

1002 fddi-default                     act/unsup

1003 token-ring-default               act/unsup

1004 fddinet-default                  act/unsup

1005 trnet-default                    act/unsup

VLAN Type  SAID       MTU   Parent RingNo BridgeNo Stp  BrdgMode Trans1 Trans2

---- ----- ---------- ----- ------ ------ -------- ---- -------- ------ ------

1    enet  100001     1500  -      -      -        -    -        0      0  

2    enet  100002     1500  -      -      -        -    -        0      0  

1002 fddi  101002     1500  -      -      -        -    -        0      0  

Purple

Cisco 4507R+E switch...svi interface is not pinging.

  Make sure any firewall on the laptop is turned off.  Also verify the address on the laptop is what you think it is by doing a ipconfig from the dos prompt  and mask and default gateway are correct.  Does interface vlan 1 show up/up when you plug your laptop in ? 

New Member

Cisco 4507R+E switch...svi interface is not pinging.

Yes sir I verified the ip address and also the status of vlan  is “up up”

661
Views
0
Helpful
4
Replies
CreatePlease login to create content