Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 4510R and slot 10

I have heard that slot 10 can only accept certain blades when you have fully populated chassis. I wasn't able to find any related information on CCO. Does anyone know about this? I plan to add a WS-X4448-GB-RJ45 and show mod look like this

Mod Ports Card Type Model Serial No.

---+-----+--------------------------------------+------------------+-----------

1 2 1000BaseX (GBIC) Supervisor(active) WS-X4516

2 2 1000BaseX (GBIC) Supervisor(standby) WS-X4516

3 48 10/100/1000BaseT (RJ45) WS-X4448-GB-RJ45

4 48 10/100/1000BaseT (RJ45) WS-X4448-GB-RJ45

5 48 10/100/1000BaseT (RJ45) WS-X4448-GB-RJ45

6 48 10/100/1000BaseT (RJ45) WS-X4448-GB-RJ45

7 48 10/100/1000BaseT (RJ45) WS-X4548-GB-RJ45

8 48 1000BaseX (SFP) WS-X4448-GB-LX

9 48 1000BaseX (SFP) WS-X4448-GB-LX

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Blue

Re: Cisco 4510R and slot 10

Hi

From Cisco doc on the 4510R chassis

=============================================

Slot 1 is reserved for the supervisor engine only, which provides switching, local and remote management, and switch-status monitoring. Slot 2 is reserved for a redundant supervisor engine only. Slots 3 through 9 are available for switching modules. When using a Supervisor Engine V, slot 10 is a flex-slot for use with the 2-port Gigabit Ethernet switching module (WS-X4302-GB) or the Access Gateway Module (WS-X4604-GWY) only. When using a Supervisor Engine V-10GE, any supported module may be used in slot 10.

=============================================

HTH

Jon

3 REPLIES
Hall of Fame Super Blue

Re: Cisco 4510R and slot 10

Hi

From Cisco doc on the 4510R chassis

=============================================

Slot 1 is reserved for the supervisor engine only, which provides switching, local and remote management, and switch-status monitoring. Slot 2 is reserved for a redundant supervisor engine only. Slots 3 through 9 are available for switching modules. When using a Supervisor Engine V, slot 10 is a flex-slot for use with the 2-port Gigabit Ethernet switching module (WS-X4302-GB) or the Access Gateway Module (WS-X4604-GWY) only. When using a Supervisor Engine V-10GE, any supported module may be used in slot 10.

=============================================

HTH

Jon

New Member

Re: Cisco 4510R and slot 10

Jon

Do you happen to have a URL for this?

Thanks.

Hall of Fame Super Blue
259
Views
0
Helpful
3
Replies