Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

cisco 4510R+E high cpu utilization on one core

Hi,

we have cisco 4510R+E switch with IOS-XE Software Version 03.01.01.SG RELEASE SOFTWARE (fc1).

our this switch is having two core & one core is always going to about 90% to 98% cpu utilization while other core is showing normal (about 5% to 10%)

we check with-

sh process cpu----- its shows iosd is taking 50.1 %

sh platform health------ it show two process is taking too much cpu using

                                   1. K5L3Unicast Adj Tabl ------ 43.14%

                                   2. K5 L2 Hardware Addre ----- 56.93%

Sh process cpu sorted------ its showing iosd is taking cpu utilization 52.25%

sh platform cpu packet statistics all------- output is attached.

all out put is attached.

This switch is gateway of our LAN.

what should further we take the action to resolve this issue.

I do not understand how to diagnose further, please help us.

Regards

vinod

9810966625

  • LAN Switching and Routing
6 REPLIES
New Member

cisco 4510R+E high cpu utilization on one core

Are you using some routing protocol on it? Debug  are all turned off?

New Member

cisco 4510R+E high cpu utilization on one core

HI Cellini,

I am team member of vinod,  no, we are not using any routing protocol and there is no debug command is turned on. we created etherchannels with HP SERVER BL670I, BL680I  HAVING load balncing methid LB_MAC and at our end channel is in ON mode . we are not able to diagnose further to resolve problem This switch is in production.

Regards,

Rajat

New Member

Re: cisco 4510R+E high cpu utilization on one core

HI Cellini,

I am team member of vinod,  no, we are not using any routing protocol and there is no debug command is turned on. we created etherchannels with HP SERVER BL670I, BL680I  HAVING load balncing methid LB_MAC and at our end channel is in ON mode . we are not able to diagnose further to resolve problem This switch is in production.

Regards,

Rajat

New Member

Re: cisco 4510R+E high cpu utilization on one core

Excuse me... i don't know vinod... can you post also the show process cpu histrory? The things who captured my attention was the

K5L3Unicast Adj Tabl.... and i found this article... http://henrydavila.wordpress.com/

hope this is helpfull

New Member

Re: cisco 4510R+E high cpu utilization on one core

thanks for your response issue is found to be mac flapping between ports that's why cpu not able to learn mac

Regards,

Rajat

New Member

Re: cisco 4510R+E high cpu utilization on one core

Happy to be helpfull...

have a nice Christmas.. and happy new year.

and don't forget to rate helpfull post for other users

4568
Views
0
Helpful
6
Replies