Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Cisco 4948-10G Console port maybe faulty

           Hi all,

I Have upgraded my Cisco 4948-10G Switch from "cat4500-ipbase-mz.122-53.SG2.bin" to "cat4500-ipbasek9-mz.150-2.SG8", and forced the system to boot using the new version "#boot config bootflash:cat4500-ipbasek9-mz.150-2.SG8", but the operation did not succeed and the switch crashed, and lost its configuration.

The switch start up now and I can see it in CDP neighborhood, but I can't access it from its console port, and there's no display on My Console client (I Hyper terminal, Putty, CRT, with several speeds from 1200 to 115200).            

There's no display, and I cannot find a way to configure the switch.

Thanks

Kader

2 REPLIES
Purple

Cisco 4948-10G Console port maybe faulty

  If you still have the old code on the switch I would try to reload that, they have had a lot of issues with 15.x code.

Cisco 4948-10G Console port maybe faulty

Yes, following cdp the switch is running its old image, but the config was lost.

No I have a problem to console it, to configure it again

238
Views
0
Helpful
2
Replies
CreatePlease login to create content