I would like to set the MTU on all the eth interfaces to 4000. I don't think this can be done per port by simply doing MTU 4000. I believe I have to set up a policy and class map to do this now then apply that map to an individual interface. I need assistance with this. i need something simple to just set the mtu size. not worried about bandwidth, priority or the like. i want this applied to both incoming and outgoing traffic.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...