03-27-2012 12:09 PM - edited 03-07-2019 05:49 AM
Hi all,
When I am manually restarting the switch, boot loader of the MSFC card entries are missing and going to rommon mode. I have to give boot command in MSFC everytime.
conf reg are same in Sp and MSFC.
I will appreciate your help
Thanks.
03-27-2012 12:12 PM
What boot statement are you using on the msfc side ?
03-27-2012 01:09 PM
Thanks for reply,
I'm using this
boot bootldr bootflash:c6msfc2-boot-mz.121-4.E1
Router(boot)#show bootvar
BOOT variable = bootflash:c6msfc2-js-mz.121-4.E1.bin,12;bootflash:c6msfc2-js-mz.121-4.E1,1;
CONFIG_FILE variable does not exist
BOOTLDR variable = bootflash:c6msfc2-boot-mz.121-4.E1
Configuration register is 0x2102
Regards.
03-27-2012 01:48 PM
You also need a boot statement pointing to the main IOS image and not just the bootloader image. Where is the main MSFC image stored? Configure a boot statement pointing to the main IOS image. Is the main image in msfc bootflash or the supervisor bootflash ? Current boot statement looks like msfc bootflash verify this . When fully booted up do a dir bootflash: and make sure the image that is specified is truly in msfc bootflash and not in like sup-bootflash or slot0: .
03-27-2012 02:11 PM
Thanks again for yor quick replay,
this is the config of MSFC:
Router(boot)#dir bootflash:
bootflash:c6msfc2-boot-mz.121-4.E1 bootflash:c6msfc2-js-mz.121-4.E1.bin
Router(boot)#dir bootflash:
Directory of bootflash:/
1 -rw- 1611604 Jan 01 2003 05:11:21 c6msfc2-boot-mz.121-4.E1
2 -rw- 7110024 Jan 01 2003 02:13:45 c6msfc2-js-mz.121-4.E1.bin
Router(boot)#show startup-config
!
version 12.1
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname Router
!
boot system bootflash:c6msfc2-js-mz.121-4.E1.bin
boot system flash bootflash:c6msfc2-js-mz.121-4.E1
boot bootldr bootflash:c6msfc2-boot-mz.121-4.E1
!
ip subnet-zero
!
!
!
no ip http server
!
line con 0
transport input none
line vty 0 4
!
end
Now is working with MSFC2, Can I reset this MSFC1? If a sinc with this command after reboot:
redundancy
high-availability
config-sync
Can I lose this config in MSFC2?
Regards.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide